fiq-debugger {
compatible = "rockchip,fiq-debugger";
rockchip,serial-id = <2>;
- rockchip,signal-irq = <135>;
+ rockchip,signal-irq = <145>;
rockchip,wake-irq = <0>;
/* If enable uart uses irq instead of fiq */
rockchip,irq-mode-enable = <0>;
rockchip,baudrate = <1500000>; /* Only 115200 and 1500000 */
status = "okay";
};
+
+ gmac_clkin: external-gmac-clock {
+ compatible = "fixed-clock";
+ clock-frequency = <125000000>;
+ clock-output-names = "gmac_clkin";
+ #clock-cells = <0>;
+ };
+
+ vcc_phy: vcc-phy-regulator {
+ compatible = "regulator-fixed";
+ regulator-name = "vcc_phy";
+ regulator-always-on;
+ regulator-boot-on;
+ };
+
+ sdio_pwrseq: sdio-pwrseq {
+ compatible = "mmc-pwrseq-simple";
+ pinctrl-names = "default";
+ pinctrl-0 = <&wifi_enable_h>;
+
+ /*
+ * On the module itself this is one of these (depending
+ * on the actual card populated):
+ * - SDIO_RESET_L_WL_REG_ON
+ * - PDN (power down when low)
+ */
+ reset-gpios = <&gpio1 18 GPIO_ACTIVE_LOW>;
+ };
+
+ wireless-wlan {
+ compatible = "wlan-platdata";
+ rockchip,grf = <&grf>;
+ wifi_chip_type = "ap6354";
+ sdio_vref = <1800>;
+ WIFI,host_wake_irq = <&gpio1 19 GPIO_ACTIVE_HIGH>;
+ status = "okay";
+ };
+
+};
+
+&cpu0 {
+ cpu-supply = <&vdd_arm>;
};
&emmc {
status = "okay";
};
+&gmac2io {
+ phy-supply = <&vcc_phy>;
+ phy-mode = "rgmii";
+ clock_in_out = "input";
+ snps,reset-gpio = <&gpio1 RK_PC2 GPIO_ACTIVE_LOW>;
+ snps,reset-active-low;
+ snps,reset-delays-us = <0 10000 50000>;
+ assigned-clocks = <&cru SCLK_MAC2IO>, <&cru SCLK_MAC2IO_EXT>;
+ assigned-clock-parents = <&gmac_clkin>, <&gmac_clkin>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&rgmiim1_pins>;
+ tx_delay = <0x26>;
+ rx_delay = <0x11>;
+ status = "disabled";
+};
+
+&io_domains {
+ status = "okay";
+
+ vccio1-supply = <&vcc_io>;
+ vccio2-supply = <&vcc_18emmc>;
+ vccio3-supply = <&vcc_io>;
+ vccio4-supply = <&vdd_18>;
+ vccio5-supply = <&vcc_io>;
+ vccio6-supply = <&vcc_io>;
+ pmuio-supply = <&vcc_io>;
+};
+
+&tsadc {
+ status = "okay";
+};
+
&u2phy {
+ otg-vbus-gpios = <&gpio0 RK_PD3 GPIO_ACTIVE_HIGH>;
status = "okay";
u2phy_host: host-port {
status = "okay";
};
+
+ u2phy_otg: otg-port {
+ status = "okay";
+ };
};
&u3phy {
- vbus-drv-gpios = <&gpio0 0 GPIO_ACTIVE_HIGH>;
+ vbus-drv-gpios = <&gpio0 RK_PA0 GPIO_ACTIVE_HIGH>;
status = "okay";
};
status = "okay";
};
+&usbdrd3 {
+ status = "okay";
+};
+
+&usbdrd_dwc3 {
+ status = "okay";
+};
+
&i2c1 {
status = "okay";
pmic {
pmic_int_l: pmic-int-l {
rockchip,pins =
- <2 6 RK_FUNC_GPIO &pcfg_pull_up>; /* gpio2_a6 */
+ <2 RK_PA6 RK_FUNC_GPIO &pcfg_pull_up>; /* gpio2_a6 */
+ };
+ };
+
+ sdio-pwrseq {
+ wifi_enable_h: wifi-enable-h {
+ rockchip,pins =
+ <1 18 RK_FUNC_GPIO &pcfg_pull_none>;
};
};
};