regulator: tps65090: Make FETs more reliable by adding retries
authorDoug Anderson <dianders@chromium.org>
Wed, 23 Apr 2014 15:56:05 +0000 (08:56 -0700)
committerMark Brown <broonie@linaro.org>
Tue, 29 Apr 2014 17:05:07 +0000 (10:05 -0700)
An issue was discovered with tps65090 where sometimes the FETs
wouldn't actually turn on when requested (they would report
overcurrent).  The most problematic FET was the one used for the LCD
backlight on the Samsung ARM Chromebook (FET1).  Problems were
especially prevalent when the device was plugged in to AC power (when
the backlight voltage was higher).

Mitigate the problem by adding retries on the enables of the FETs,
which works around the problem fairly effectively.

Signed-off-by: Doug Anderson <dianders@chromium.org>
Signed-off-by: Simon Glass <sjg@chromium.org>
Signed-off-by: Michael Spang <spang@chromium.org>
Signed-off-by: Sean Paul <seanpaul@chromium.org>
Reviewed-by: Simon Glass <sjg@chromium.org>
Signed-off-by: Mark Brown <broonie@linaro.org>
drivers/regulator/tps65090-regulator.c

index ca04e9f010e1bddd4704a4aec59f5ec3cc6d6d7a..2057e2e311de94704d2cdcc3691c15d994571e60 100644 (file)
@@ -17,6 +17,7 @@
  */
 
 #include <linux/module.h>
+#include <linux/delay.h>
 #include <linux/init.h>
 #include <linux/gpio.h>
 #include <linux/of_gpio.h>
 #include <linux/regulator/of_regulator.h>
 #include <linux/mfd/tps65090.h>
 
+#define MAX_CTRL_READ_TRIES    5
+#define MAX_FET_ENABLE_TRIES   1000
+
+#define CTRL_EN_BIT            0 /* Regulator enable bit, active high */
 #define CTRL_WT_BIT            2 /* Regulator wait time 0 bit */
+#define CTRL_PG_BIT            4 /* Regulator power good bit, 1=good */
+#define CTRL_TO_BIT            7 /* Regulator timeout bit, 1=wait */
 
 #define MAX_OVERCURRENT_WAIT   3 /* Overcurrent wait must be <= this */
 
@@ -80,40 +87,158 @@ static int tps65090_reg_set_overcurrent_wait(struct tps65090_regulator *ri,
        return ret;
 }
 
-static struct regulator_ops tps65090_reg_contol_ops = {
+/**
+ * tps65090_try_enable_fet - Try to enable a FET
+ *
+ * @rdev:      Regulator device
+ *
+ * Return: 0 if ok, -ENOTRECOVERABLE if the FET power good bit did not get
+ * set, or some other -ve value if another error occurred (e.g. i2c error)
+ */
+static int tps65090_try_enable_fet(struct regulator_dev *rdev)
+{
+       unsigned int control;
+       int ret, i;
+
+       ret = regmap_update_bits(rdev->regmap, rdev->desc->enable_reg,
+                                rdev->desc->enable_mask,
+                                rdev->desc->enable_mask);
+       if (ret < 0) {
+               dev_err(&rdev->dev, "Error in updating reg %#x\n",
+                       rdev->desc->enable_reg);
+               return ret;
+       }
+
+       for (i = 0; i < MAX_CTRL_READ_TRIES; i++) {
+               ret = regmap_read(rdev->regmap, rdev->desc->enable_reg,
+                                 &control);
+               if (ret < 0)
+                       return ret;
+
+               if (!(control & BIT(CTRL_TO_BIT)))
+                       break;
+
+               usleep_range(1000, 1500);
+       }
+       if (!(control & BIT(CTRL_PG_BIT)))
+               return -ENOTRECOVERABLE;
+
+       return 0;
+}
+
+/**
+ * tps65090_fet_enable - Enable a FET, trying a few times if it fails
+ *
+ * Some versions of the tps65090 have issues when turning on the FETs.
+ * This function goes through several steps to ensure the best chance of the
+ * FET going on.  Specifically:
+ * - We'll make sure that we bump the "overcurrent wait" to the maximum, which
+ *   increases the chances that we'll turn on properly.
+ * - We'll retry turning the FET on multiple times (turning off in between).
+ *
+ * @rdev:      Regulator device
+ *
+ * Return: 0 if ok, non-zero if it fails.
+ */
+static int tps65090_fet_enable(struct regulator_dev *rdev)
+{
+       int ret, tries;
+
+       /*
+        * Try enabling multiple times until we succeed since sometimes the
+        * first try times out.
+        */
+       tries = 0;
+       while (true) {
+               ret = tps65090_try_enable_fet(rdev);
+               if (!ret)
+                       break;
+               if (ret != -ENOTRECOVERABLE || tries == MAX_FET_ENABLE_TRIES)
+                       goto err;
+
+               /* Try turning the FET off (and then on again) */
+               ret = regmap_update_bits(rdev->regmap, rdev->desc->enable_reg,
+                                        rdev->desc->enable_mask, 0);
+               if (ret)
+                       goto err;
+
+               tries++;
+       }
+
+       if (tries)
+               dev_warn(&rdev->dev, "reg %#x enable ok after %d tries\n",
+                        rdev->desc->enable_reg, tries);
+
+       return 0;
+err:
+       dev_warn(&rdev->dev, "reg %#x enable failed\n", rdev->desc->enable_reg);
+       WARN_ON(1);
+
+       return ret;
+}
+
+static struct regulator_ops tps65090_reg_control_ops = {
        .enable         = regulator_enable_regmap,
        .disable        = regulator_disable_regmap,
        .is_enabled     = regulator_is_enabled_regmap,
 };
 
+static struct regulator_ops tps65090_fet_control_ops = {
+       .enable         = tps65090_fet_enable,
+       .disable        = regulator_disable_regmap,
+       .is_enabled     = regulator_is_enabled_regmap,
+};
+
 static struct regulator_ops tps65090_ldo_ops = {
 };
 
-#define tps65090_REG_DESC(_id, _sname, _en_reg, _ops)  \
+#define tps65090_REG_DESC(_id, _sname, _en_reg, _en_bits, _ops)        \
 {                                                      \
        .name = "TPS65090_RAILS"#_id,                   \
        .supply_name = _sname,                          \
        .id = TPS65090_REGULATOR_##_id,                 \
        .ops = &_ops,                                   \
        .enable_reg = _en_reg,                          \
-       .enable_mask = BIT(0),                          \
+       .enable_val = _en_bits,                         \
+       .enable_mask = _en_bits,                        \
        .type = REGULATOR_VOLTAGE,                      \
        .owner = THIS_MODULE,                           \
 }
 
 static struct regulator_desc tps65090_regulator_desc[] = {
-       tps65090_REG_DESC(DCDC1, "vsys1",   0x0C, tps65090_reg_contol_ops),
-       tps65090_REG_DESC(DCDC2, "vsys2",   0x0D, tps65090_reg_contol_ops),
-       tps65090_REG_DESC(DCDC3, "vsys3",   0x0E, tps65090_reg_contol_ops),
-       tps65090_REG_DESC(FET1,  "infet1",  0x0F, tps65090_reg_contol_ops),
-       tps65090_REG_DESC(FET2,  "infet2",  0x10, tps65090_reg_contol_ops),
-       tps65090_REG_DESC(FET3,  "infet3",  0x11, tps65090_reg_contol_ops),
-       tps65090_REG_DESC(FET4,  "infet4",  0x12, tps65090_reg_contol_ops),
-       tps65090_REG_DESC(FET5,  "infet5",  0x13, tps65090_reg_contol_ops),
-       tps65090_REG_DESC(FET6,  "infet6",  0x14, tps65090_reg_contol_ops),
-       tps65090_REG_DESC(FET7,  "infet7",  0x15, tps65090_reg_contol_ops),
-       tps65090_REG_DESC(LDO1,  "vsys-l1", 0,    tps65090_ldo_ops),
-       tps65090_REG_DESC(LDO2,  "vsys-l2", 0,    tps65090_ldo_ops),
+       tps65090_REG_DESC(DCDC1, "vsys1",   0x0C, BIT(CTRL_EN_BIT),
+                         tps65090_reg_control_ops),
+       tps65090_REG_DESC(DCDC2, "vsys2",   0x0D, BIT(CTRL_EN_BIT),
+                         tps65090_reg_control_ops),
+       tps65090_REG_DESC(DCDC3, "vsys3",   0x0E, BIT(CTRL_EN_BIT),
+                         tps65090_reg_control_ops),
+
+       tps65090_REG_DESC(FET1,  "infet1",  0x0F,
+                         BIT(CTRL_EN_BIT) | BIT(CTRL_PG_BIT),
+                         tps65090_fet_control_ops),
+       tps65090_REG_DESC(FET2,  "infet2",  0x10,
+                         BIT(CTRL_EN_BIT) | BIT(CTRL_PG_BIT),
+                         tps65090_fet_control_ops),
+       tps65090_REG_DESC(FET3,  "infet3",  0x11,
+                         BIT(CTRL_EN_BIT) | BIT(CTRL_PG_BIT),
+                         tps65090_fet_control_ops),
+       tps65090_REG_DESC(FET4,  "infet4",  0x12,
+                         BIT(CTRL_EN_BIT) | BIT(CTRL_PG_BIT),
+                         tps65090_fet_control_ops),
+       tps65090_REG_DESC(FET5,  "infet5",  0x13,
+                         BIT(CTRL_EN_BIT) | BIT(CTRL_PG_BIT),
+                         tps65090_fet_control_ops),
+       tps65090_REG_DESC(FET6,  "infet6",  0x14,
+                         BIT(CTRL_EN_BIT) | BIT(CTRL_PG_BIT),
+                         tps65090_fet_control_ops),
+       tps65090_REG_DESC(FET7,  "infet7",  0x15,
+                         BIT(CTRL_EN_BIT) | BIT(CTRL_PG_BIT),
+                         tps65090_fet_control_ops),
+
+       tps65090_REG_DESC(LDO1,  "vsys-l1", 0, 0,
+                         tps65090_ldo_ops),
+       tps65090_REG_DESC(LDO2,  "vsys-l2", 0, 0,
+                         tps65090_ldo_ops),
 };
 
 static inline bool is_dcdc(int id)