spi: mediatek: use BIT() to instead of SPI_CMD_*_OFFSET
authorLeilk Liu <leilk.liu@mediatek.com>
Thu, 20 Aug 2015 09:19:08 +0000 (17:19 +0800)
committerMark Brown <broonie@kernel.org>
Thu, 20 Aug 2015 18:16:12 +0000 (11:16 -0700)
This patch removes SPI_CMD_*_OFFSET defines, and uses the BIT(x)
defines instead.

Signed-off-by: Leilk Liu <leilk.liu@mediatek.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
drivers/spi/spi-mt65xx.c

index 55d1c3e51864a6a53becc3ccef833b4d99e8127b..516b4ed757e5827531a86bf56a7057b3418bb9a0 100644 (file)
 #define SPI_CFG1_PACKET_LOOP_MASK         0xff00
 #define SPI_CFG1_PACKET_LENGTH_MASK       0x3ff0000
 
-#define SPI_CMD_ACT_OFFSET                0
-#define SPI_CMD_RESUME_OFFSET             1
-#define SPI_CMD_CPHA_OFFSET               8
-#define SPI_CMD_CPOL_OFFSET               9
-#define SPI_CMD_TXMSBF_OFFSET             12
-#define SPI_CMD_RXMSBF_OFFSET             13
-#define SPI_CMD_RX_ENDIAN_OFFSET          14
-#define SPI_CMD_TX_ENDIAN_OFFSET          15
-
+#define SPI_CMD_ACT                  BIT(0)
+#define SPI_CMD_RESUME               BIT(1)
 #define SPI_CMD_RST                  BIT(2)
 #define SPI_CMD_PAUSE_EN             BIT(4)
 #define SPI_CMD_DEASSERT             BIT(5)
@@ -143,9 +136,14 @@ static void mtk_spi_config(struct mtk_spi *mdata,
        reg_val = readl(mdata->base + SPI_CMD_REG);
 
        /* set the mlsbx and mlsbtx */
-       reg_val &= ~(SPI_CMD_TXMSBF | SPI_CMD_RXMSBF);
-       reg_val |= (chip_config->tx_mlsb << SPI_CMD_TXMSBF_OFFSET);
-       reg_val |= (chip_config->rx_mlsb << SPI_CMD_RXMSBF_OFFSET);
+       if (chip_config->tx_mlsb)
+               reg_val |= SPI_CMD_TXMSBF;
+       else
+               reg_val &= ~SPI_CMD_TXMSBF;
+       if (chip_config->rx_mlsb)
+               reg_val |= SPI_CMD_RXMSBF;
+       else
+               reg_val &= ~SPI_CMD_RXMSBF;
 
        /* set the tx/rx endian */
 #ifdef __LITTLE_ENDIAN
@@ -201,9 +199,14 @@ static int mtk_spi_prepare_message(struct spi_master *master,
        cpol = spi->mode & SPI_CPOL ? 1 : 0;
 
        reg_val = readl(mdata->base + SPI_CMD_REG);
-       reg_val &= ~(SPI_CMD_CPHA | SPI_CMD_CPOL);
-       reg_val |= (cpha << SPI_CMD_CPHA_OFFSET);
-       reg_val |= (cpol << SPI_CMD_CPOL_OFFSET);
+       if (cpha)
+               reg_val |= SPI_CMD_CPHA;
+       else
+               reg_val &= ~SPI_CMD_CPHA;
+       if (cpol)
+               reg_val |= SPI_CMD_CPOL;
+       else
+               reg_val &= ~SPI_CMD_CPOL;
        writel(reg_val, mdata->base + SPI_CMD_REG);
 
        chip_config = spi->controller_data;
@@ -282,9 +285,9 @@ static void mtk_spi_enable_transfer(struct spi_master *master)
 
        cmd = readl(mdata->base + SPI_CMD_REG);
        if (mdata->state == MTK_SPI_IDLE)
-               cmd |= 1 << SPI_CMD_ACT_OFFSET;
+               cmd |= SPI_CMD_ACT;
        else
-               cmd |= 1 << SPI_CMD_RESUME_OFFSET;
+               cmd |= SPI_CMD_RESUME;
        writel(cmd, mdata->base + SPI_CMD_REG);
 }