*/
if (mc13892_regulators[id].vsel_reg != MC13892_SWITCHERS0) {
+ mask |= MC13892_SWITCHERS0_SWxHI;
+
if (volt > 1375000) {
reg_value -= MC13892_SWxHI_SEL_OFFSET;
reg_value |= MC13892_SWITCHERS0_SWxHI;
- mask |= MC13892_SWITCHERS0_SWxHI;
- } else if (volt < 1100000) {
+ } else {
reg_value &= ~MC13892_SWITCHERS0_SWxHI;
- mask |= MC13892_SWITCHERS0_SWxHI;
}
}
static struct regulator_ops mc13892_sw_regulator_ops = {
.list_voltage = regulator_list_voltage_table,
+ .map_voltage = regulator_map_voltage_ascend,
.set_voltage_sel = mc13892_sw_regulator_set_voltage_sel,
.get_voltage_sel = mc13892_sw_regulator_get_voltage_sel,
};
struct mc13xxx_regulator_init_data *mc13xxx_data;
struct regulator_config config = { };
int i, ret;
- int num_regulators = 0, num_parsed;
+ int num_regulators = 0;
u32 val;
num_regulators = mc13xxx_get_num_regulators_dt(pdev);
if (num_regulators <= 0)
return -EINVAL;
- num_parsed = num_regulators;
-
priv = devm_kzalloc(&pdev->dev, sizeof(*priv) +
num_regulators * sizeof(priv->regulators[0]),
GFP_KERNEL);
= mc13892_vcam_get_mode;
mc13xxx_data = mc13xxx_parse_regulators_dt(pdev, mc13892_regulators,
- ARRAY_SIZE(mc13892_regulators),
- &num_parsed);
-
- /*
- * Perform a little sanity check on the regulator tree - if we found
- * a number of regulators from mc13xxx_get_num_regulators_dt and
- * then parsed a smaller number in mc13xxx_parse_regulators_dt then
- * there is a regulator defined in the regulators node which has
- * not matched any usable regulator in the driver. In this case,
- * there is one missing and what will happen is the first regulator
- * will get registered again.
- *
- * Fix this by basically making our number of registerable regulators
- * equal to the number of regulators we parsed. We are allocating
- * too much memory for priv, but this is unavoidable at this point.
- *
- * As an example of how this can happen, try making a typo in your
- * regulators node (vviohi {} instead of viohi {}) so that the name
- * does not match..
- *
- * The check will basically pass for platform data (non-DT) because
- * mc13xxx_parse_regulators_dt for !CONFIG_OF will not touch num_parsed.
- *
- */
- if (num_parsed != num_regulators) {
- dev_warn(&pdev->dev,
- "parsed %d != regulators %d - check your device tree!\n",
- num_parsed, num_regulators);
-
- num_regulators = num_parsed;
- priv->num_regulators = num_regulators;
- }
+ ARRAY_SIZE(mc13892_regulators));
- for (i = 0; i < num_regulators; i++) {
+ for (i = 0; i < priv->num_regulators; i++) {
struct regulator_init_data *init_data;
struct regulator_desc *desc;
struct device_node *node = NULL;