-* Samsung S2MPS11, S2MPS13, S2MPS14 and S2MPU02 Voltage and Current Regulator
+* Samsung S2MPS11/13/14/15 and S2MPU02 Voltage and Current Regulator
The Samsung S2MPS11 is a multi-function device which includes voltage and
current regulators, RTC, charger controller and other sub-blocks. It is
addressed by the host system using different I2C slave addresses.
Required properties:
-- compatible: Should be "samsung,s2mps11-pmic" or "samsung,s2mps13-pmic"
- or "samsung,s2mps14-pmic" or "samsung,s2mpu02-pmic".
+- compatible: Should be one of the following
+ - "samsung,s2mps11-pmic"
+ - "samsung,s2mps13-pmic"
+ - "samsung,s2mps14-pmic"
+ - "samsung,s2mps15-pmic"
+ - "samsung,s2mpu02-pmic".
- reg: Specifies the I2C slave address of the pmic block. It should be 0x66.
Optional properties:
- interrupt-parent: Specifies the phandle of the interrupt controller to which
the interrupts from s2mps11 are delivered to.
- interrupts: Interrupt specifiers for interrupt sources.
+- samsung,s2mps11-wrstbi-ground: Indicates that WRSTBI pin of PMIC is pulled
+ down. When the system is suspended it will always go down thus triggerring
+ unwanted buck warm reset (setting buck voltages to default values).
- samsung,s2mps11-acokb-ground: Indicates that ACOKB pin of S2MPS11 PMIC is
connected to the ground so the PMIC must manually set PWRHOLD bit in CTRL1
register to turn off the power. Usually the ACOKB is pulled up to VBATT so
when PWRHOLD pin goes low, the rising ACOKB will trigger power off.
Optional nodes:
-- clocks: s2mps11, s2mps13 and s5m8767 provide three(AP/CP/BT) buffered 32.768
+- clocks: s2mps11, s2mps13, s2mps15 and s5m8767 provide three(AP/CP/BT) buffered 32.768
KHz outputs, so to register these as clocks with common clock framework
instantiate a sub-node named "clocks". It uses the common clock binding
documented in :
the clock which they consume.
Clock ID Devices
----------------------------------------------------------
- 32KhzAP 0 S2MPS11, S2MPS13, S2MPS14, S5M8767
- 32KhzCP 1 S2MPS11, S2MPS13, S5M8767
- 32KhzBT 2 S2MPS11, S2MPS13, S2MPS14, S5M8767
+ 32KhzAP 0 S2MPS11, S2MPS13, S2MPS14, S2MPS15, S5M8767
+ 32KhzCP 1 S2MPS11, S2MPS13, S2MPS15, S5M8767
+ 32KhzBT 2 S2MPS11, S2MPS13, S2MPS14, S2MPS15, S5M8767
- compatible: Should be one of: "samsung,s2mps11-clk", "samsung,s2mps13-clk",
"samsung,s2mps14-clk", "samsung,s5m8767-clk"
+ The s2msp15 uses the same compatible as s2mps13, as both provides similar clocks.
- regulators: The regulators of s2mps11 that have to be instantiated should be
included in a sub-node named 'regulators'. Regulator nodes included in this
- S2MPS11: 1 to 38
- S2MPS13: 1 to 40
- S2MPS14: 1 to 25
+ - S2MPS15: 1 to 27
- S2MPU02: 1 to 28
- Example: LDO1, LDO2, LDO28
- BUCKn
- S2MPS11: 1 to 10
- S2MPS13: 1 to 10
- S2MPS14: 1 to 5
+ - S2MPS15: 1 to 10
- S2MPU02: 1 to 7
- Example: BUCK1, BUCK2, BUCK9