4 - power-supply: regulator to provide the supply voltage
7 - compatible: value maybe one of the following
11 - ddc-i2c-bus: phandle of an I2C controller used for DDC EDID probing
12 - enable-gpios: GPIO pin to enable or disable the panel
13 - backlight: phandle of the backlight device attached to the panel
15 Required properties when compatible is "simple-panel" or "simple-panel-dsi":
16 - display-timings: see display-timing.txt for information
18 Optional properties when compatible is a dsi devices:
19 - dsi,flags: dsi operation mode related flags
20 - dsi,format: pixel format for video mode
21 - dsi,lanes: number of active data lanes
22 - reset-gpios: GPIO pin to reset the panel
23 - reset-delay-ms: reset pulse width
24 - panel-init-sequence: A byte stream formed by simple multiple dcs packets.
26 byte 1: wait number of specified ms after dcs command transmitted
27 byte 2, 3: 16 bits length in network byte order
28 byte 4 and beyond: number byte of payload
29 - panel-exit-sequence: A byte stream formed by simple multiple dcs packets.
31 byte 1: wait number of specified ms after dcs command transmitted
32 byte 2, 3: 16 bits length in network byte order
33 byte 4 and beyond: number byte of payload
38 compatible = "cptt,claa101wb01";
39 ddc-i2c-bus = <&panelddc>;
41 power-supply = <&vdd_pnl_reg>;
42 enable-gpios = <&gpio 90 0>;
44 backlight = <&backlight>;
49 compatible = "simple-panel-dsi";
50 ddc-i2c-bus = <&panelddc>;
52 power-supply = <&vdd_pnl_reg>;
53 enable-gpios = <&gpio 90 0>;
55 reset-gpios = <&gpio 91 0>;
56 reset-delay-ms = <20>;
58 backlight = <&backlight>;
60 dsi,flags = <MIPI_DSI_MODE_VIDEO |
61 MIPI_DSI_MODE_VIDEO_BURST |
62 MIPI_DSI_MODE_VIDEO_SYNC_PULSE>;
63 dsi,format = <MIPI_DSI_FMT_RGB888>;
66 panel-init-sequence = [
67 39 00 00 10 b1 6c 15 15 24 E4 11 f1 80 e4
74 panel-exit-sequence = [
80 native-mode = <&timing0>;
82 clock-frequency = <160000000>;
94 pixelclk-active = <0>;